Vera Olkhovskaya
Once the pants are cut, start by checking for the following pieces and trimming the missing ones.
For dress pants, you should have the following:
PP - front half 2 pcs.
Details for processing PP pockets:
1. Valances for pockets of the "cut-off barrel" type - 2 pcs.
2. Burlap - 2 pcs.
3. Lining (if necessary) - 2 pcs.
ZP - rear half 2 pcs.
Details for processing the pocket on the right ZP.
1. L?stochka or facing for the frame (2 pcs. for one pocket). Width 2,5 cm, length exceeds the length of the pocket by 3 cm.
2. Valance (for a frame or leaves) or valve. The width exceeds the length of the pocket by 4-5 cm, the height is 8 cm.
3. Burlap: the width is equal to the width of the gap - about 20 cm, length - 35 - 40 cm.
4. Air loop - unfolded length 6 cm. Can be made from the same fabric as the trousers or from a braid that matches the color.
Belt details 2 pcs., since the belt consists of two halves. The length of each half is
St + 10 cm,
and the width is
belt width + 2 cm
Loops - 6 pcs, and if St exceeds 45 cm - 7 pcs.
Pants for figures with a protruding belly can be supplemented with a loop for a peg (see photo on the right).
See video lesson on the technique of cutting small parts of trousers
Pants patterns
Women's patterns of trousers and shorts, overalls, skirts:
Men's patterns of trousers and other clothes:
|