I had to change the depth of the sleeves and the shoulders already, otherwise they stuck out.
Before cutting this dress, it is extremely important to choose the correct length. Like the choice of sizes, the length is best compared with the finished product, but can be measured by the figure.
To correct the length of the pattern, put the excess in the warehouse in the area marked with hatching and pin it off.
We cut out the facings of the neck and sprout (the neck of the back) according to the patterns of the back and the shelves from dublerin or interlining without seam allowances (picture 2). Later, you will be able to stick these piping blanks on the fabric and cut out the piping blanks already with the necessary seam allowances.
Once again, the sequence for turning: cut out from dublerin without allowances, stick it on the fabric that remained after cutting the shelves and back with the necessary allowances.
For cutting, fold the dublerin in half with the adhesive side inward and circle the upper sections of the shelf and back. The width of the facing in narrow places is 3,5 - 4 cm. Please note that the facings of the neck and armholes are combined for this model.
On the back, you can make a figured cutout in the form of a drop or a heart (figure 2 b ).Cutting the dress is not difficult - the “jack” layout (picture 3) , the parts are laid out in the most economical way.
Other patterns of trapeze dresses
This season most often sew according to my following patterns:
|