Vera Olkhovskaya
Jeans Prep: rip off the belt, cut off or open the side and crotch seams, cut off the seam of the seat and bottom.
Leave the pocket of PP "cutting barrels" - we use it in the product.
At the end of the PP and ZP jeans should be ironed well.
Preparation of vest patterns (see the construction of a drawing of a men's vest) getting started from the construction of the shelf relief.
This is done on the pattern of the base of the vest.
Divide in half the shoulder section of the shelf and the segment located on the horizontal of the barrel from the corner of the armhole to the half-skid.
The procedure for re-tailoring a men's vest from jeans
On fig. 1, all segments that need to be divided are indicated by curly brackets.
Connect the division points, and from the bottom, which is at the level of the barrel, lower the perpendicular to the bottom and even lower by 4 - 5 cm for the design of the curly line of the bottom.
Dart on the shoulder cut of the back built in the same way as on women's products,
but as men tend to be somewhat more stooped, the opening of the tuck can be increased to 2 cm.
It must be remembered that the position of the tuck should be determined by the position of the relief on the front, so that when connecting the shoulder sections of the front and back, the reliefs coincide.
Construction of the relief of the back.
Divide in half the segments that determine the width of the back at the level of the barrel and at the level of the bottom.
Connect the division points smoothly between each other and with the top of the tuck.
Finally, cut the side of the shelf for processing the pocket, departing from the horizontal bottom 11 - 13 cm.
Seam allowances: the neck-sprout and the armhole are cut out of the line, the edge of the bead 0,7 - 1 cm, the rest 1 or 1,5 см.
Layout: it is important not only to observe the share direction of the thread, but also to bypass dilapidated places if possible.
Figure 2 shows the location of the parts and their duplicates on the front halves of old jeans, in Figure 3, respectively, the parts are laid out on the back halves.
The worn-out places are marked in dark color.
Please note: the detail of the "barrels of the shelf" is laid on the side pocket of the PP jeans.
On fig. Pocket 2 is marked with a red dotted line.
Pickup trimmed after trying on (Fig. 4) according to the details of the cut.
It should follow the contour of the neck, the edge of the side and partially the bottom.
If the vest is made without lining, then you will also have to cut out the facings of the sprout and armholes.
The turning of the sprout and the pick can be one piece.
All processing details are cut out from the remaining lunges and therefore can consist of several parts.
If the area of lunges for turning and picking is not enough, they can be cut from another fabric of a similar color.
Pocket processing in the side houryou shelves performed very simply.
To the bottom of the barrel of the shelf (which was cut out in the area of the pocket of the PP jeans), stitch the burlap, and then the belt from the jeans from which you cut out the vest.
Stitch the burlap to the top of the shelf barrel as well.
Then fold the two parts of the barrel of the shelf in such a way that they make up a whole barrel, congruent to the pattern of the same name before cutting it into two parts and cover the entrance to the pocket.
It remains only to stitch-overcast the burlap and put on the sides of the entrance to the pocket of the backtack.
Ready-made patterns of life-size vests
Download ready-made patterns of vests
Patterns for men's clothing
Join my community on Viber...
